Let me start by thanking all who contributed to this great project!
I have a question if there is an ‘easy’ way to add custom actions to the interface - I have my RPi-based Volumio connected to my Denon receiver. This is a network-enabled receiver so can be controlled via http requests directly.
Ideally I’d love to be able to add receiver power on/off button, turn on second zone, etc to the Volumio interface so that I control everything from one place instead of needing to switch to another app or physical remote, this would involve actually adding these controls to the UI.
But if I could at least use the existing volume control to send volume up/down signals to the receiver this would be a great start.
Any advice where should I start looking would be very appreciated.