Udoo Quad - Unrecognized filesystem type

Help and Support Help
1

I have bought myself an uDOO quad recently and am having trouble setting up volumio. My only previous setups on the uDOO were arch based ones. Being such I am used to the arch setup process. Does anyone have any helpful pointers to setting up an uDOO quad with Volumio? Everytime I try I receive the following:


U-Boot 2015.01 (Jan 24 2015 - 18:35:39) Arch Linux ARM

CPU:   Freescale i.MX6Q rev1.2 at 792 MHz
Reset cause: POR
Board: Udoo
DRAM:  1 GiB
MMC:   FSL_SDHC: 0
In:    serial
Out:   serial
Err:   serial
Net:   using phy at 6
FEC [PRIME]
Hit any key to stop autoboot:  0
switch to partitions #0, OK
mmc0 is current device
SD/MMC found on device 0
Checking for: /boot/uEnv.txt ...
Failed to mount ext2 filesystem...
** Unrecognized filesystem type **
Failed to mount ext2 filesystem...
** Unrecognized filesystem type **

Thank you all for your support and help!

2

Hi:

I’m a noob to all this but have been working through getting my UDOO-Quad up and running under Volumio.
It sounds to me like you need to reformat your SD Card (or try a new one). Make sure you have downloaded the correct version of Volumio (1.5) and I would check the SHA1 hash count to assure you have no corruption with the downloaded file.

The Volumio.org site has excellent directions for performing the install process.
I have encountered a few permission glitches and some odd UI functionality situation but my Quad is up and running and playing music.

Good luck.
Dennis