Raspberry pi 2
Hifiberry
USB hard drive
IR remote control
Digital out.
(speakers are work in progress)
Raspberry pi 2
Hifiberry
USB hard drive
IR remote control
Digital out.
(speakers are work in progress)
hello.
very nice project. how did you implement lirc and the display in volumio2?
best regards
paul
I think a lot of us are trying to find the answer to this question. Seems like every time it’s been asked there has been no response. I know I’ve got a project on hold until I can figure it out.
Very nice project, by the way. Very similar to what I am trying to do.
Sorry to say, its Volumio 1.55.
Will be trying to update it to 2 soon.
I figured it was 1.55. If you can get Ver 2 to work there at quite a few of us that would appreciate it if you would share the knowledge!
very nice sprocket1597!
How did you setup the gpio_in and gpio_out of your IR receiver?
With my Pi I couldn’t find a way to have the Pi 2 B HifiBerry Dac pro and + the IR fully working all together.
In order to receive some information via IR I had to remove the DAC from the PI and setup the GPIO as following:
With this conf I can receive, record or send IR through my IR ener314-ir.
As soon as I add the DAC I can’t received IR and keeping the GPIO like below breaks the Pi. He doesn’t want to boot.
I have to change the setup for:
And here with Volumio 1.55 or 2 it work but I can only send IR data. I’m not able to receive IR data.
Also do you have some noise when you send IR data through your PI? I have a weird noise each time I’m sending IR order I can ear through my speaker (Volumio 1 et 2).
Are you experiencing the same thing?
Here is my installation
I’m working on how to develop a lirc plug in for my Pi.
This is the interface I would love to have
1:55 and not because you use the new version?
can someone tell me a simple guide to install a 4 inch lcd hdmi monitor