i have some of these ir sensors here https://www.amazon.com/gp/product/B087ZRD3LH/ref=ppx_od_dt_b_asin_title_s00?ie=UTF8&psc=1 .What gpio pins on the board do i connect them to and how do i enable the sensor on Volumio to work.
1 VCC external 3.3v
2 GND External GND
3 DO small board digital output interface
please do not suggest to power the IR receiver with 5V, the RPi pins are not 5V tollerant, you can break them
the IR receiver should be connected to 3.3V
It can run on 3.3v @Darmur but i just Copied the pin out on this IR
Ps. I changed the 5v to 3.3v