Hello, i tried it a few times but i cannot get the GPIO Plugin working. I have a Raspi 4 + Allo boss. (without the Allo Volt)
I tried to use the J19 pinheader GPIO 17 & GPIO 27 with my Pushbutton closing to GND with no reaktion.
I tried also GPIO 26 directly from the Raspi to GND also with no success - no reaktion.
The Plugin is endabled, GPIO pin numbers are right. I triple checked everything, tried a few times and researched a lot. I cannot get it working. What is my problem here? I just want to add a shutdown button, with this heavy electricity prices here in Austria these days. Thanks so much Christian
Did I look over something? Nobody has an idea? thanks Christian
1 Like
Hey I saw this and thought I’d add what I found.
I’ve got a Allo Boss (mini) and am also using GPIO 17 22 and 27 with a rotary encoder.
You dont say but have you got any pull up resistors ? Eg 10KOhm to the 3.3V Rail.
I believe you can set the pullup \down in software but the default is to pull down - which would mean that the inputs are always appearing closed.
Hope this helps
Steve